Monday, October 31, 2016

Fishing Techniques - The 6 Best Bass


Whether you're a weekend bass warrior or a new tournament angler looking for more tricks of the trade, these critical techniques should be mastered to maximize performance and success


Learning more techniques and becoming a more diverse angler will lead to more lunker-size bass, like this one, on future fishing trips.
One of the reasons bass are North America’s most popular gamefish is they’re somewhat easier to catch than other species, primarily because they are so abundant. But, just because these fish can be found virtually everywhere doesn’t always mean you’ll always load the boat on every fishing trip. It’s more than just tossing out a bait and hoping there’s a hungry bass near by willing to bite; consistantly catching lunkers comes down to proper technique. Below are critical techniques you should master to maximize your performance and success as a bass angler.

Pitching and Flipping

When bass aren't all that active and are hiding in thick cover, it’s as if you have to go into stealth mode to catch those shy lunkers. The best methods for getting to shallow-water thick cover, without spooking fish too much, are pitching and flipping. These methods are similar looking techniques, but some occasions require one over the other, especially as it pertains to distance. The key to successful pitching and flipping is practice, a long rod -- 6 1/2-foot to 7 1/2-foot -- and the right soft-plastic bait.

Pitching

Pitching is the easier of the two techniques but is not as precise as flipping. Let out enough line so it’s about even with the reel, and keep your reel open (button pressed). With your thumb on the reel spool, lower the rod tip towards the water and with your free hand, grab hold of the lure (worm, tube jigs, creatures) and pull on the line to add tension. In one smooth motion let go of the lure while swinging your rod tip up. As the swings away toward your target, remove your thumb from the reel spool. The timing of these steps will take some practice. This combination should slingshot the bait towards your target. Be sure to close the reel as soon as the bait lands because bass often strike quickly.

Flipping

Flipping takes more practice, but once you get a good feel for it, you can optimize your presentation and hit your target location more precisely than pitching. Begin by letting out somewhere between 8 to 15 feet of line and then close your reel. Grab the line between the reel and first rod guide and then extend your arm to the side as you pull on the line. Raise the rod and the bait will now swing towards you. Using a pendulum motion, swing the bait to your desired location while feeding the line through your hand. Tighten up the remaining slack and get ready for a strike. It looks a little awkward, but it’s a great way to get a drop on some shy bass.

Topwater

For many anglers, there’s nothing more exciting than catching a bass with a topwater bait. The sound of the lure, the sight of an approaching fish, and the exhilaration of seeing a big splash when a largemouth finally strikes can be enough to get anyone’s heart racing. Unlike pitching or flipping, topwater lures are meant for hungry, active fish. It’s a true “lure,” designed to attract attention with noise and dramatic movements.
There are several kinds of topwater baits, like poppers, jitterbugs and frogs. Some topwaters are easy to use and work best with a slow, steady retrieve, like a jitterbug. Others take some more technique. The aptly named "popper' requires an angler to literally pop the lure as it is retrieved, pausing every few seconds and allowing it to go steady, imitating a wounded fish. The sporadic stopping and moving can drive bass crazy.
Another popular retrieving method is called "walk the dog," commonly used for soft-frog or Zara spook-type baits. Walking the dog is where you quickly twitch the rod tip up and down for the duration of the slow retrieve.
Winning Techniques: Click here for topwater tips with hardbaits.

Crankbaits

A crankbait is all about reflex for a bass. They won’t want to chase it down the same way they would for a topwater bait, but even so, noise and presentation is still key to using a crankbait correctly. Crankbaits are a favorite for many tournament anglers because they can be used to cover a lot of water, both horizontally and vertically at a variety of depths.
Crankbaits work best around solid objects, like rocks, logs and stumps. It is possible to use a crankbait along the side of a weedbed, but generally drop-offs and rocky shoals with plenty of solid cover works best. The more you get to know the feel of the way your crankbait swims through the water and bumps into objects, the better you will be at catching bass.
Think of crankbaits as a teasing lure. Grab the fish’s attention by reeling quickly, then stopping and allowing the crankbait to slowly rise. Then reel up again and make another stop. This can drive bass crazy. When using a deep diver, you can try the "bumping the stump" technique to tease fish into biting. As you reel in and feel your crankbait strike bottom or something hard, like a rock, stop and let the lure float a little bit. All that noise and movement will bring bass in and wanting to feast on what they think is easy prey.
Must Watch: Check out Karl Kolonka fishing crankbaits.

Spinnerbaits

Spinnerbaits are a little trickier than crankbaits because it can be harder to successfully hook a fish given the design of the lure. However, once hooked with a sprinnerbait, it's harder for a bass to throw the bait than when compared to a crankbait. Spinnerbaits are a great year-round lure that can produce results on any given day on any given lake. Retrieval should range from slow to medium speed and works best around solid cover and vegetation.
There are several different ways to use the versatile spinnerbait. One method is to allow the bait to fall to the bottom near a dropoff. As it hits bottom, reel up the slack, give it a few cranks and then allow it to fall to the bottom again. Keep repeating. For the most part, however, you’ll be reeling in continuously at different paces. The slower you reel in, the deeper the bait tends to swim through the water column. When you reel in at a faster rate, it will swin higher in the water column. Running a spinnerbait just below the surface will create a wake that some fish will find irresistible. You can even break the surface from time to time to mimic active bait fish.

                                             Source: By Piter shenr

Types of Fishing Line



Fishing line provides the connection between you and the fish. From hook to rod, every motion, every tug, every drag-screaming run flows through the line to the angler.
  FISHING LINE TYPES
Fishing line comes in several types but the two most commonly used are monofilament and braid. Monofilament is made from nylon and is one long continuous filament, whereas braided fishing line is made up of several super-strong, very thin fibers made from material similar to Kevlar braided together to form a line that is basically round in cross section.
MONOFILAMENT LINE
Advantages : Monofilament is the most popular type of fishing line and comes in a great variety of strengths and colors. Mono is less expensive than other lines, stretches to absorb shocks, is abrasion resistant, and uniformly round in cross section, which helps keep it neat on the spool. Monofilament is easy to tie knots in, but can suffer from “memory” where it loops in the shape of the spool. Mono comes in several shades, but clear and blue are popular because they disappear underwater and are very difficult for a fish to see.
Disadvantages: Monofilament is not as strong as braid for a given diameter, so higher pound test mono takes up more space on a spool. It’s also nylon, which means it breaks down over time when exposed to sunlight, so it’s important to respool with fresh line every year.
BRAID FISHING LINE
Advantages: Braid is very strong for a given diameter, often twice as strong as mono, so you can pack more line on a spool at a given pound test. That also means it sinks faster, casts farther, and trolls deeper than mono. Braid has no memory so loops and twists aren’t a problem. Braid doesn’t break down in sunlight, so you can keep it on the spool year after year. And it doesn’t stretch at all, so you can feel every bump of the bottom and nudge from a fish.
Disadvantages: Braid is very slippery so you have to use knots that can hold despite the low friction. Braid is so strong it’s difficult to cut — you have to carry nail clippers or very sharp scissors. And though it comes in several colors, it’s not see-through like mono. Most anglers use a leader when fishing with braid to help hide the line from the fish. It’s also less abrasion resistant than mono. And finally, braid has no stretch, which means there’s no give when a fish strikes, so using less drag is a good idea, and a bit more finesse when setting the hook helps as well.
Fluorocarbon Fishing Line: Fluorocarbon is often used as leader material. It’s completely invisible underwater and very abrasion resistant, making it the perfect complement to braid. There are now a few brands of fluorocarbon being sold as a main line.


Wire Fishing Line: Wire is another leader material that is used when fishing for toothy fish like mackerel and tuna. Wire comes in single strand and braided varieties. Wire also is popular for some types of trolling where reaching deep depths is important. This requires special hardened spools for the reels.
Fly Fishing Line: Fly line comes in particular weights. These don’t reference the breaking strength, but instead the heaviness of the line, which needs to match up with the fly rod. Fly line attaches to a leader called a tippet which comes in different breaking strengths.
One of the best fishing line set-ups is using a leader - a short length of fishing line that attaches to the main line at one end, and the hook or lure at the other. Leaders can be made of a different material than the main line, or simply be a thicker, heavier version of the main line if, for example, increased abrasion resistance is required. Leaders allow you to improve your success hooking and keeping fish, without having to cast and retrieve an entire line made of the bigger, heavier material. This is especially important when using a wire leader.
  • The most important characteristic of all fishing line types is its breaking strength, the amount of force the line can hold before it parts. This is expressed as pound-test. So 10-lb test fishing line should hold 10 pounds before it breaks and 30-lb test holds 30 and so on.
  • Many things can weaken a line, including the knots you tie in it. It’s important to choose a line that is strong enough for your needs within a working margin. You should assume that even brand new line will provide less than 80% of its rated strength once you’ve tied a hook or lure to it.
  • Early fishing lines were braided natural materials like silk and therefore quite expensive, modern lines are made from synthetic materials like nylon, dacron, dyneema, and fluorocarbon.


MOST POPULAR TYPES OF FISHING LINE

OTHER TYPES OF FISHING LINE

FISHING WITH LEADERS